Roland VS-2480 - Manual (Page 140)

10—Using the Digital Mixer
140 www.rolandus.com Roland VS-2480 Owner’s Manual
Activating Knob Control of Dynamics and EQ Parameters
1. If the AUX SEND•PRM EDIT button is:
•
lit red —the PAN/AUX SEND 1-8 knobs are set to control the selected channel’s
dynamics and EQ parameters
• not lit —press the button repeatedly until it’s lit red.
• lit green —press the flashing KNOB/FDR ASSIGN•AUX 1-8 button in the
LOCATOR/MARKER/SCENE area of the VS-2480’s top panel.
2. Activate control of the channel by pressing the FADER button that selects the set of
channels that includes the desired channel.
3. Press the CH EDIT button for the channel whose parameters you wish to adjust.
4. Turn the desired PAN/AUX SEND 1-8 knob to adjust a parameter’s value.
The KNOB/FDR ASSIGN•AUX SEND 1-8 Button
The KNOB/FDR ASSIGN•AUX SEND 1-8 button—located to the right of
the VS-2480’s numeric keypad—allows you to set the PAN/AUX SEND
1-8 knobs or the channel faders so that you can use them to:
• send each channel’s signal to one of the Aux busses.
• adjust the value of a selected channel parameter in any channel.
You can use the KNOB/FADER ASSIGN feature when you want to quickly adjust the
selected Aux send or desired channel parameter for multiple input, track or FX return
channels.
To Set What the KNOB/FADER ASSIGN Feature Controls
1. Press UTILITY.
2. Press PAGE repeatedly until GLOBAL appears above F2.
3. Press F2 (GLOBAL).
4. Press , , or , if necessary, to select the KNOB/FDR ASSIGN Sw parameter.
5. Turn the TIME/VALUE dial to select:
•
Knob —to use the KNOB/FADER ASSIGN feature with the PAN/AUX SEND 1-8
knobs.
• Fader —to use the KNOB/FADER ASSIGN feature with the channel faders.
6. Press F6 (EXIT).
This feature works with either the PAN/AUX SEND 1-8 knobs or the channel faders—
not both at once. If it’s already turned on when you change the setting of the KNOB/
FDR ASSIGN Sw parameter in Step 5 above, and the switch had previously been set to:
• Knob —the PAN/AUX SEND 1-8 knobs return to the control of panning or the
currently selected channel’s dynamics and EQ parameters, as determined by the
setting of the AUX SEND•PRM EDIT button (Page 139).
• Fader —each fader returns to the control of its channel’s signal level.
While the above steps describe selecting the desired channel after activating the knobs
for channel-parameter control, you can select the channel first if you prefer.
VS2480OMUS.book 140 ページ ２００６年２月７日 火曜日 午後４時１６分