Roland VS-2480 - Manual (Page 43)

2—Getting Around
Roland VS-2480 Owner’s Manual www.rolandus.com 43
2—PREVIEW TO•PROJECT TOP Button
Press PREVIEW TO to listen to the last few moments leading up to the current location
of the timeline—you can set how much you want to hear. Hold SHIFT and press
PREVIEW TO to jump to the start, or “top,” of the audio recorded in the project.
3—PREVIEW THRU Button
Press PREVIEW THRU to listen to a small chunk of audio leading up to the current
location of the timeline and a small chunk that plays after it, as determined by the
PREVIEW TO and PREVIEW FROM time settings.
4—PREVIEW FROM•PROJECT END Button
Press PREVIEW FROM to listen to what occurs just after the current location of the
timeline—you can set how much you want to hear. Hold SHIFT and press PREVIEW
FROM to jump to the end of the audio recorded in the project.
5—EXT SYNC Button
Press EXT SYNC so that it lights to synchronize the VS-2480’s playback to an external
MTC- or SMPTE-generating device. Press it again so that it’s not lit when you want the
VS-2480 itself to provide the master timing reference (this is the VS-2480’s normal
operating mode). Synchronization is described in Chapter 24. Hold down SHIFT and
press EXT SYNC to jump to the VS-2480’s synchronization settings.
6—ZERO•STORE Button
Press ZERO•STORE to return to the beginning of the project (Time 00h00m00s00f00)—
see Page 126. Hold down SHIFT and press ZERO•STORE to save the current state of
your project to your hard drive.
7—STOP•SHUT/EJECT Button
Press STOP to halt playback at the timeline’s current location—see Page 122. Hold
down SHIFT and press STOP•SHUT/EJECT to power down the VS-2480—you’ll be
asked if you want to save your project first—and to eject any mounted Zip drive
cartridges.
8—PLAY•RESTART Button
Press PLAY•RESTART to begin playback from the current location of the timeline—see
Page 122. Hold down SHIFT and press PLAY •RESTART to restart the VS-2480 instead
of turning it off after you’ve performed a shutdown procedure (SHIFT + STOP•SHUT/
EJECT).
PREVIEW TO, PREVIEW THRU and PREVIEW FROM work together, and are all
described in detail in “Preview” on Page 183.
MTC, SMPTE
VS2480OMUS.book 43 ページ ２００６年２月７日 火曜日 午後４時１６分