Roland VS-2480 - Manual (Page 145)

10—Using the Digital Mixer
Roland VS-2480 Owner’s Manual www.rolandus.com 145
Recalling a Scene
1. Press SCENE•BANK if it’s not already lit.
2. If the current scene bank contains the scene you want, press the scene’s lit button
on the keypad. To recall a scene from a different bank, follow the instructions in
“Changing Scene Banks” and then press the scene’s button in the desired bank.
Changing Scene Banks
1. Press SCENE•BANK if it’s not already lit. If any scenes are stored in the currently
selected scene bank, their buttons light on the numeric keypad.
2. While holding down SHIFT, press SCENE•BANK. The button for the currently
selected bank lights solidly, and the other keypad buttons flash.
3. Press 0-9 to select the desired scene bank—if scenes are stored there, their
numbers light on the keypad.
Clearing a Scene
1. Press SCENE•BANK if it’s not already lit. If you’d like to clear a scene from a
different bank, see the instructions in “Changing Scene Banks” before proceeding.
2. While holding down CLEAR, press the desired scene’s button on the keypad. The
scene is cleared from that location, and the button’s light turns off.
Leaving Scene Mode
With its default settings, after you store or recall a scene, the VS-2480 reverts to Locator
mode and the numeric keypad goes back to its normal job of recalling locators
(Page 185)—this is intended to help you get right back to navigating your way through
the project. You can change this default behavior if you wish so that Scene mode
remains active—and the SCENE button remains lit—until you manually leave it.
1. Press UTILITY.
2. If you don’t see “GLOBAL” above F2, press PAGE until it you do.
3. Press F2 (GLOBAL).
4. If F1 (Param1) isn’t highlighted, press F1 (Param1).
5. You can set the RETURN TO LOCATE Sw parameter to:
•
On —to automatically return to Locate mode after you store or recall a scene.
• Off —so that you return to Locate mode by manually pressing LOCATE.
6. Press F6 (EXIT) to confirm your changes.
Editing Scenes
You can edit scenes on the UTILITY menu’s SCENE screen. You can name them, clear
them, store and recall them, and select the channels whose settings are to be recalled.
1. Press UTILITY and press PAGE repeatedly until “SCENE” appears above F1.
2. Press F1 (SCENE).
Click noise come out occasionally when switching scene. This is not because of system
problem.
The VS-2480 time-
stamps each scene when
it’s created, as shown on
this screen.
VS2480OMUS.book 145 ページ ２００６年２月７日 火曜日 午後４時１６分