Roland VS-2480 - Manual (Page 223)

16—Using Effects
Roland VS-2480 Owner’s Manual www.rolandus.com 223
Match the Patch to the Project
When a project’s sampling rate is 64 kHz or higher—see Page 96—patches based on the
following algorithms become grayed out and can’t be used:
• Reverb • Gate Reverb • Vocoder2 (19)
• Voice Transformer • Mic Modeling • Speaker Modeling
• Mastering Tool Kit
Selecting an Effect Patch
To navigate to an effect’s PATCH SELECT screen if you’re not already there:
1. Press EFFECT.
2. If the F button for the desired effect processor isn’t visible, press PAGE.
3. Press the processor’s F button to display its Algorithm View screen.
4. Press F1 (PATCH).
To select an effect patch on the PATCH SELECT screen:
1. Press F1 (PRESET) to jump to the first preset effect patch in the patch list, or press
F2 (USER) to jump to the first user patch.
2. Turn the TIME/VALUE dial to select the desired patch. You can use the dial to scroll
through all of the preset and user patches if you want to.
3. Press F5 (SELECT) to load the selected effect patch.
Editing Effect Patches
Press F3 (EDIT) on an effect processor’s Algorithm View screen to view the first editing
screen for the selected effect patch. In the illustration below, you can see the two
editing screens for the first effect patch, P000 Reverb.
Each algorithm provides a set of parameters with which you can change the effect
processing it produces. To learn about each algorithm’s parameters, see the
VS-2480 Appendices . When you edit a patch, you edit the values for the algorithm—or
algorithms—on which the patch is based.
The VS-2480 Appendices contains an effect patch list that tells you whether a patch is
designed for use as a loop or insert effect. The list also tells you if the patch has stereo
inputs—so it treats its left and right sides independently—or if its input is mono.
The BYPASS switch is explained on Page 220. Press F6 (EXIT) to return to the
processor’s Algorithm View screen.
VS2480OMUS.book 223 ページ ２００６年２月７日 火曜日 午後４時１６分