Roland VS-2480 - Manual (Page 376)

28—UTILITY Menu Parameters
376 www.rolandus.com Roland VS-2480 Owner’s Manual
Correcting Problems
You can correct most problems by inserting a stereo graphic EQ—such as Effect Patch
P031—on the VS-2480’s MASTER bus. You can adjust the sound of the speakers using
the graphic EQ’s settings, returning frequently to the analyzer to check your work.
DATE/TIME
To learn how to set the VS-2480’s calendar and clock that time-stamp
your recordings, see “Setting the VS-2480’s Clock” on Page 65.
Parameter Initialization
Use the MIXER/UTILITY PARAMETER INITIALIZE screen to reset many of the
VS-2480’s mixer and/or UTILITY menu parameters to their default factory settings. You
may want to do this to start over with a clean slate, or if your VS-2480 is behaving oddly,
and you suspect that some unknown parameter value may be the cause.
Resetting Mixer and UTILITY Parameters
1. Press UTILITY.
2. Press PAGE until “PrmIni” appears above F6.
3. Press F6 (PrmIni).
4. Turn the TIME/VALUE dial to select:
•
MIXER & UTILITY —to initialize both the mixer and UTILITY parameters.
• MIXER —to initialize only the mixer parameters.
• UTILITY —to initialize only the UTILITY parameters.
5. Press F5 (OK)—a confirmation screen appears.
6. If you’re sure you want to proceed, press ENTER/YES. To cancel the operation,
press EXIT/NO.
If you’re having trouble correcting a problem, try analyzing the sound of each monitor
by pointing the mic straight at it. Return to the center perspective for a final check.
This screen doesn’t initialize all mixer and/or UTILITY menu settings. Your basic
project settings remain, including your current IDE drive selection. Scenes, the tempo
map and sync track, SCSI ID, LOCATOR/SCENE TYPE, SHIFT LOCK and NUMERICS
TYPE parameters are among the settings that aren’t initialized.
If this procedure doesn’t cure your VS-2480’s odd behavior, call Roland Product
Support at 323-890-3740, x3741.
UTILITY menu
F5 (DATE)
UTILITY menu
F6 (PrmIni)
VS2480OMUS.book 376 ページ ２００６年２月７日 火曜日 午後４時１６分