Roland VS-2480 - Manual (Page 187)

13—Operating the Hard Disk Recorder
Roland VS-2480 Owner’s Manual www.rolandus.com 187
4. Press or or turn the TIME/VALUE dial to select the desired locator. You can:
• press F1 (NAME) to rename (Page 73) the selected locator.
• press F2 (CLEAR) to delete the selected locator.
• press F3 (GetNow) to reset the locator to the timeline’s current position.
• Press F4 (GO TO) to move the timeline to the selected locator’s position.
5. Press F6 (EXIT) when you’re done to confirm your changes.
Switching Automatically to Locator Mode
You can set the VS-2480 so that it remains in Scene mode after recalling and storing
scenes, or so it automatically returns to Locator mode after either action.
1. Press UTILITY.
2. If you don’t see “GLOBAL” above F2, press PAGE until you do.
3. Press F2 (GLOBAL).
4. If F1 (Param1) isn’t highlighted, press F1 (Param1).
5. You can set the RETURN TO LOCATE Sw parameter to:
•
On —to automatically return to Locate mode after you store or recall a scene.
• Off —so that you return to Locate mode by manually pressing LOCATE.
6. Press F6 (EXIT) to confirm your changes.
Locators in Safe Mode
If you prefer to work with locators a bit more slowly and carefully, you can use Safe
mode. Safe mode allows you to work with locators in a LOCATOR window that shows
each locator’s number and name. You can also store and clear locators in Safe mode.
While this is a slower way to work, it provides greater certainty that you’ve got the right
locator.
The UTILITY menu’s LOCATOR/SCENE TYPE parameter turns Safe mode on or off—
see Page 364. Its default value is Quick. To turn on Safe mode, select Safe.
Recalling a Locator in Safe Mode
1. Press LOCATOR—the LOCATOR window opens.
2. Turn the TIME/VALUE dial to scroll through the list
until the desired locator is in view.
3. Enter the locator’s two-digit number on the keypad—
an arrow appears to the left of the locator in the list,
and “Locate? appears in the window.
4. Press ENTER/YES to recall the selected locator and close the window, or just press
ENTER/NO twice to leave the window without recalling a locator.
You can store a new locator at the timeline’s current position by scrolling to an unused
locator line and pressing F3 (GetNow).
VS2480OMUS.book 187 ページ ２００６年２月７日 火曜日 午後４時１６分