Roland VS-2480 - Manual (Page 194)

13—Operating the Hard Disk Recorder
194 www.rolandus.com Roland VS-2480 Owner’s Manual
Performing an Auto Punch
1. Set your Auto Punch IN and OUT points as described above.
2. Press A.PUNCH so it’s lit.
3. Move to a convenient location in the project before the location you want to punch.
4. Press the track’s TRACK STATUS button so it flashes red.
5. Press REC so it flashes red.
6. Press PLAY.
7. If you want to dual-monitor the track (Page 191), press the track’s TRACK STATUS
button again—it blinks red and amber and you can hear the recorded track and
your source signal.
When the timeline reaches the punch-in point recording automatically begins and
the TRACK STATUS and REC buttons light solidly red. When the timeline gets to
the punch-out point, recording automatically stops and the TRACK STATUS and
REC buttons resume flashing.
8. To turn Auto Punch off, press A.PUNCH so it’s not lit.
VS2480OMUS.book 194 ページ ２００６年２月７日 火曜日 午後４時１６分