Omega RD260A - Manual (Page 16)

2 - 4
2.2 Wiring
!
Wiring should be done only after you have read this section. The section consists of the
following subsections:
2.2.1 Rear Panel Terminal Arrangement
2.2.2 Power Supply Wiring
2.2.3 Input Signal Wiring
2.2.4 Alarm Output Wiring
2.2.5 Remote Control Wiring
Make sure to fasten the wiring at the rear wall of the mounting panel and
employ some kind of strain relief between the rear wall and the recorder.
2.2.1 Rear Panel Terminal Arrangement
Pen model
The terminal blocks can be detached from the case by removing
these screws for easy wiring.
Tighten the terminal screws properly to ensure proper contact.
Optional terminals
Power terminal
Input terminals
Terminal screw: ISO M4, nominal length 6 mm
L
N
Dot-printing model
The terminal blocks can be detached from the case by removing
these screws for easy wiring.
Tighten the terminal screws properly to ensure proper contact.
Optional terminals
Power terminal
Input terminals
Terminal screw: ISO M4, nominal length 6 mm
L
N
WARNING