Omega RD260A - Manual (Page 23)

3 - 2
3.1 Front Panel
RCD ALM
ESC
RCD PRINT FEED
➀
➂
➁ ➃
➄
DISP CH UP
1. Power switch (push-button type)
Pressing the switch turns the power ON and OFF.
2. Key panel (push-key type)
The panel contains five keys.
[RCD] key
Pressing the key starts or stops the recording.
DISP
ESC
[DISP] key, [ESC] key
(DISP function) Cycles through the modes of display in the order of
AUTO, MANUAL, DATE, TIME and OFF. Also
selects between the OPERATION and SET modes
pressing for three seconds.
(ESC function) Exits from the menu in the middle of setting or selecting
procedures.
PRINT
[PRINT] key, [ ] key
(PRINT function) Conducts the list printout (see subsection 4.6.1) and the
SET UP list printout (see subsection 4.6.2).
( function) Selects setting parameters (numerics or command
codes). Selecting step is upward circulation.
FEED
[FEED] key, [ ] key
(FEED function) The chart is fed as long as this key is being pressed (see
subsection 4.5.2.)
( function) Changes the number of digits for setting numeric
values. The digit moves from high to low.
CH UP
[CH UP] key, [ENT] key
(CH UP function) Selects a channel for which the display shows the screen
in the MANUAL display mode.
( function) Makes a parameter entry or executes a function after
selecting parameters (numerals or command codes).
Pressing the key executes the settings.