4 setting upscale/downscale tc burnout – Omega RD260A User Manual
Page 76
7 - 5
7. SET UP MODE
7.4 Setting Upscale/Downscale TC Burnout
7.4 Setting Upscale/Downscale TC Burnout
The purpose of the following setting is to specify where the pens will move in the case
of a TC-burnout. You can choose from moving to the right (UP) or to the left (DOWN).
This is common for every channel. You can select ON or OFF for each channel.
The initial value is ‘UP’, and ‘OFF’ for every channel.
SETTING PROCEDURE:
Enter the SET UP mode by turning ‘ON’ the power while pressing and holding the [CH
UP] (
ENT) key until the SET UP display appears.
Use the [
] key to select the display [
]. Press the [ENT] key.
Use the [
] key to select the display [
]. Press the [ENT] key.
Select [
] or [
] using the [
] key. Press the [ENT] key.
The display [
] appears.
This burnout processing is ON/OFF selectable per channel.
Press the [ENT] key.
Use the [
] key to select the display [
]. Press the [ENT] key.
Select the channel No. using the [
] key for which you want to specify this burnout
processing. Then press the [ENT] key.
Select ‘ON’ or ‘OFF’. Then press the [ENT] key. The display [
] appears.
Before leaving the SET UP mode, you have to store your new settings. Use the [
] key
to select the [
] display, and press the [ENT] key.
Select [
] to keep your new settings or [
] to abort the settings, and
press the [ENT] key. After a few seconds, the OPERATION mode will appear.