Omega RD260A - Manual (Page 33)

4 - 8
4.6 Getting a Digital Printout
A digital printout can be any one of the following:
• List printout
• SET UP list printout
4.6.1 Getting a List Printout
A list printout includes the following setting values:
• Date/time/chart speed/2nd-chart speed/trend record interval (Dot-printing model)
• Channel number/range/span/scaling value/engineering unit
• Tag/offset value (if setting is on)
• Types of set alarms (if set)
• Message setting (if set up to 16 characters)
List printing is executed by the following procedure:
(1) Press the[PRINT] key.
(2) Press the [
] (PRINT) key to call up the [ ] display, then press the
[ENT] key.
(3) Press the [ ] key to select [ ], press the [ENT] key, and list printing
will start.
When list printing starts, the display automatically returns to the screen that was on
display before the printing began.
NOTE • While list printing is executed, analog recording is interrupted; however,
measuring and alarm detecting activities continue.
• If an alarm occurs during list printout, the alarm printout starts just after the
analog recording restarts.
If you want to interrupt a list printing, proceed as follows:
(1) Press the [PRINT] key.
(2) Press the [
] (PRINT) key to call up the [ ] display, then press the
[ENT] key.
(3) Press the [ ] key to select [ ], and press the [ENT] key. The list printing
will stop and the recorder will return to the state before starting the list printing.
When the OFFSET or
TAG setting is on in
SET UP mode, this is
printed.
Pen model Printing Sample