Omega RD260A - Manual (Page 4)

2
WARNING
CAUTION
SAFETY PRECAUTIONS
This recorder is developed to satisfy and to be used under the following conditions:
• The recorder is a component type instrument to be installed on an instrumentation
panel or rack.
• The recorder complies with EN61010-1.
• The recorder conforms to EN55011 (EMI) Group 1, Class A (for commercial and
industrial use).
• This instrument complies with Installation (over-voltage) Category II.
The following safety precautions must be observed during all phases of operation,
maintenance, and repair of the recorder. If this instrument is used in a manner not
specified in this manual, the protection provided by this instrument may be impaired.
Also OMEGA assumes no liability for the customer’s failure to comply with these
requirement.
General definitions of safety symbols used on the recorder and in this manual.
Monitory symbol; the elements marked with this symbol alert the user to refer to the
instruction manual to avoid personal injury or recorder damage.
Protective grounding terminal; this terminal must be connected to the ground before
turning the power switch on.
High temperature; to avoid injury caused by hot surface, don’t touch the heats in.
Alternative current;
This manual uses the following signs for safety precautions:
A WARNING sign denotes a hazard. It calls attention to a procedure, practice,
condition or the like, which, if not correctly performed or adhered to, could result
in personal injury or death of personnel.
A CAUTION sign denotes a hazard. It calls attention to a procedure, practice,
condition or the like, which, if not correctly performed or adhered to, could result
in damage to or destruction of part or all of the recorder.
Power Supply
Ensure the source voltage matches the specified power supply voltage before
turning on the power.