Omega RD260A User Manual
Page 84
7 - 13
7. SET UP MODE
7.12 Turning Printing of Changes in Chart Speed On/Off
7.12 Turning Printing of Changes in Chart Speed On/Off
You can select the new chart speed printed on the chart when the chart speed changes.
Note that the chart speed will not be printed when the chart speed exceeds 1800 mm/h
(Pen model) or 120 mm/h (Dot-printing model).
The initial value is ‘OFF’.
SETTING PROCEDURE:
Enter the SET UP mode by turning ‘ON’ the power while pressing and holding the [CH
UP] (
ENT) key until the SET UP display appears.
Use the [
] key to select the display [
]. Press the [ENT] key.
Press the [
] key until the display [
] will appear and press the [ENT] key. Use
the [
] key to select ‘ON’ or ‘OFF’.
The display [
] appears.
Before leaving the SET UP mode, you have to store your new settings. Use the [
] key
to select the [
] display, and press the [ENT] key.
Select [
] to keep your new settings or [
] to abort the settings, and
press the [ENT] key. After a few seconds, the OPERATION mode will appear.