Omega RD260A User Manual
Page 85
7 - 14
7.13 Turning Printing of Channel Numbers On/Off (Dot-printing model)
If turned on, this function prints each channel number next to the measured value at
approximately 25-mm intervals. The default value is ‘ON’.
Note that no channel number will be printed if the chart speed exceeds 120mm/h.
SETTING PROCEDURE:
Enter the SET UP mode by turning ‘ON’ the power while pressing and holding the [CH
UP] (
ENT) key until the SET UP display appears.
Use the [
] key to select the display [
]. Press the [ENT] key.
Use the [
] key to select the display [
]. Press the [ENT] key.
Using the [
] key, select either ‘ON’ or ‘OFF’ and then press the [ENT] key. The
display [
] will appear.
Before leaving the SET UP mode, you have to store your new settings. Use the [
] key
to select the [
] display, and press the [ENT] key.
Select [
] to keep your new settings or [
] to abort the settings, and
press the [ENT] key. After a few seconds, the OPERATION mode will appear.