Oceanic Watch / Dive Computer GEO User Manual
Page 126
126
Closely examine the threads of the Battery Hatch and
Housing for any signs of damage that might prevent
proper threading.
Closely examine the inside of the Battery Compartment for
any signs of corrosion indicating entrance of moisture into
the unit.
If corrosion is found, return the GEO to an Authorized
Oceanic Dealer, and DO NOT attempt to use it until it has
received factory service.
If moisture is found, it is best to have the unit inspected
and cleaned by an Authorized Oceanic Dealer.
If it is necessary to clean the Battery Compartment, flush it
and all components with a solution of 50% white vinegar
and 50% fresh water. Rinse with fresh water, and allow to
dry overnight or blow dry with a hair dryer set at no heat.
Battery Installation
Slide a new 3 volt type CR2430 Lithium Battery, negative
side down into the Battery Cavity. Slide it in from the Left
side (Fig. 120) and ensure that it slides under the contact
clip on the lower/right rim of the cavity.
Lightly lubricate the new Hatch O-ring with silicone grease
and place it on the inner rim of the Battery Hatch. Ensure
that it is evenly seated (Fig. 121).
Fig. 120 - BATTERY
INSTALLATION
Fig. 121 - BATTERY
HATCH O-RING