Trimble Outdoors R7 - Manual (Page 158)

1 6 Software Utilities
1 4 6 Trimble R7/R8 GPS Receiver User Guide
Tr
imble R8 Operation
8. Click Add . The new frequency appears in the Selected
Frequencies list.
Note – The frequencies that you program must conform to the
channel spacing and minimum tuning requirements for the
radio. To view this information, click
Radio Info . You may
select either 12.5 or 25 kHz channel spacing. All radios in your
network must use the same channel spacing.
9. When you have configured all the frequencies you require, click
OK .
WinFlash updates the receiver radio frequencies and then
restarts the receiver.
Note – You can only configure receive frequencies. The FCC approved
transmit frequencies must be specified and configured by Trimble.
160.1
Configuring the internal 900 MHz radio setup
To configure the internal 900 MHz radio, use one of the following:
• Trimble Survey Controller running on a Trimble controller
• WinFlash (provided on the Trimble R7, Trimble R8, 5700, and
5800 GPS Receivers CD)
The internal radio has 40 available networks. You must choose the
same network that is configured in the base radio you want to receive
from.
Trimble Survey Controller
To configure your radio network using Trimble Survey Controller:
1. Connect to the Trimble R8 receiver with Bluetooth (or the
appropriate data cable if necessary).
2. From the main menu on the controller, select Configuration.
3. In the dialog that appears, select Survey styles, then from the
Type field, select RTK.