Configuring the internal 900 mhz radio setup, Tr imble r7 operation – Trimble Outdoors R7 User Manual
Page 88
7 Software Utilities
7 6 Trimble R7/R8 GPS Receiver User Guide
Tr
imble R7 Operation
9.
When you have configured all the frequencies you require, click
OK
.
WinFlash updates the receiver radio frequencies and then
restarts the receiver.
70.1
Configuring the internal 900 MHz radio setup
To configure the internal 900 MHz radio, use one of the following:
•
Trimble Survey Controller running on a Trimble controller
•
WinFlash (provided on the Trimble R7, Trimble R8, 5700, and
5800 GPS Receivers CD)
The internal radio has 40 selectable networks. You must choose the
same network that is configured in the base radio you want to receive
from.
Trimble Survey Controller
To configure the radio network using Trimble Survey Controller:
1.
Connect the data/power cable to the controller and the receiver
and turn on the controller. The receiver starts automatically.
2.
From the main menu on the controller, select Configuration.
3.
In the dialog that appears, select Survey styles, then from the
Type field, select RTK.
4.
Select Rover radio, then from the Type field select Trimble
Internal.
5.
Tap the
!
softkey.
6.
Once connected, in the Network number field enter the number
of the network set on your base radio.
Note – The Base Radio Mode field is not used here.
7.
Tap the
E
softkey to complete configuration.