Trimble Outdoors R7 - Manual (Page 162)

1 6 Software Utilities
1 5 0 Trimble R7/R8 GPS Receiver User Guide
Tr
imble R8 Operation
– Avoid Strong Signals. The carrier detect mode is on, but
the radio will stop transmitting only when there is a strong
signal present (receive level greater than 90 dBm).
5. If you are operating in Base mode, select the Enable Station ID
check box and then enter your call sign in the Call Sign field.
This FCC requirement is for U.S. licensed users. It sets your
radio to transmit your call sign in Morse code every 15 minutes.
6. To update the configuration, click OK .
In the Status dialog that appears, select an option to return to the
main menu or to exit WinFlash.
B
Tip – You can print or save the radio configuration information for future
reference. If required, you can fax or e-mail the file to Trimble Support to
aid in troubleshooting radio problems.
Updating the frequency list
You can program the internal transceiver modem with a list of up to 20
frequencies, which are stored in non-volatile memory. This list is
pre-configured based on the frequencies that you requested when you
ordered the unit. Government regulations stipulate that only
manufacturers or authorized dealers can create this frequency list and
that all frequencies programmed into a unit must comply with the host
country regulations. If you need to add, delete, or replace frequencies,
contact your Trimble dealer, and provide the radio modem serial
number and an updated list of the frequencies you require. Once you
receive the frequency file, you can upgrade the radio using WinFlash.