Trimble Outdoors R7 - Manual (Page 4)

This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
S TATEMENT ACCORDING FCC PART 15.21
Modifications not expressly approved by Trimble
could void the user's authority to operate the
equipment.
S TATEMENT ACCORDING FCC PART 15.105
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment
and receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV
technician for help.
Type Approval
Type approval, or acceptance, covers technical
parameters of the equipment related to emissions
that can cause interference. Type approval is
granted to the manufacturer of the transmission
equipment, independent from the operation or
licensing of the units. Some countries have unique
technical requirements for operation in particular
radio-modem frequency bands. To comply with
those requirements, Trimble may have modified
your equipment to be granted Type approval.
Unauthorized modification of the units voids the
Type approval, the warranty, and the operational
license of the equipment.
Safety
E XPOSURE TO R ADIO F REQUENCY
R ADIATION
You must maintain a minimum separation distance
of 20 cm (approximately 8 in.) between yourself
and the radiating GSM antenna for this device to
satisfy the RF Exposure requirements of the FCC.
For mobile operation, the maximum gain of the
GSM antenna must not exceed 0 dBi.