Tandberg Data SDLT 600 - Manual (Page 4)

SDLT 600 Product Manual
iv
Attention!
Ceci est un produit de Classe A. Dans un environnement domestique, ce produit risque de créer des
interférences radioélectriques, il appartiendra alors à l'utilisateur de prendre les mesures spécifiques
appropriées.
User Manual Statements for Class B Equipment
(Tabletop SDLT 600 Tape Drive System)
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
that may cause undesirable operation.
Any modifications to this device—unless expressly approved by the manufacturer—can void the user’s
authority to operate this equipment under Part 15 of the FCC rules.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio or TV technician for help.
Note: Additional information on the need to interconnect the device with shielded (data) cables or the
need for special devices, such as ferrite beads on cables, is required if such means of interference