Tandberg Data SDLT 600 - Manual (Page 73)

SDLT 600 Product Manual Chapter 4: Installing Your Tape Drive
81-81184-02 REV A01 March 2004 4-25
The tabletop unit power supply has an auto-sensing feature; it requires no adjustment or switch setting
changes for different AC sources.
Refer to Figure 4-9 and Figure 4-12 . Connect one end of the AC cord into the power connector on the
back of the tabletop tape drive; connect the other end of the cord to the AC outlet. Upon completion,
proceed to the next section to confirm the installation.
4.7 Confirming the Installation
To confirm the installation, power on the SDLT 600 tape drive system and the host computer. The
screens displayed at power-on contain BIOS, operating system, and SCSI controller information. If the
first screen displays host adapter and SCSI ID information, then the installation is successful. Refer to
“Troubleshooting” on page 5-12 if the installation is not successful.