Tandberg Data SDLT 600 - Manual (Page 70)

Configuring and Installing a Tabletop Tape Drive SDLT 600 Product Manual
4-22 March 2004 81-81184-02 REV A01
Figure 4-10. SCSI ID Selector Switch for the SDLT 600 Tape Drive Tabletop Model
TERMPWR
The factory preconfigures the TERMPWR setting for the tabletop tape drive according to specific
customer requirements. You can not select TERMPWR on site.
4.6.2 Installing the Tabletop Tape Drive
Tabletop tape drive installation consists of connecting SCSI bus and power cables.
Figure 4-9 on page 4-21 shows the location of the two SCSI bus connectors and power connector on
the back of the tabletop tape drive.
SCSI Cables
You can connect the SCSI bus cable leading from the host adapter to either of the tape drive SCSI
connectors. If the tape unit is the last device on the bus, then you should install a SCSI terminator on
the open connector. If the bus continues from the tape drive to another SCSI device, then install a SCSI
3
3
SCSI ID
Selector