Tandberg Data SDLT 600 - Manual (Page 68)

Configuring and Installing a Tabletop Tape Drive SDLT 600 Product Manual
4-20 March 2004 81-81184-02 REV A01
4.5.5 Connect the Fibre Channel Cable
1. Fibre Channel cables are “hot-swappable”—meaning you may connect and disconnect them with
unit power on. Therefore, unlike other systems, the tape drive and computer may remain on to
connect the SDLT 600 tape drive to the host computer.
2. Insert the fiber optic cable into the Fibre Channel port on the back of the tape drive as shown in
Figure 4-8 . The connector is fully seated when it snaps into the port.
Figure 4-8. Connecting the SDLT 600 Fibre Channel Cable
4.6 Configuring and Installing a Tabletop Tape
Drive
This section provides instructions for configuring and installing the tabletop model of the SDLT 600
tape drive.
N OTE : The tabletop model comes ONLY with the SCSI interface. The Fibre
Channel interface is not available.
Fibre Channel
Cable SDLT 600
Tape Drive