Tandberg Data SDLT 600 - Manual (Page 50)

Safety, Handling, and ESD Protection SDLT 600 Product Manual
4-2 March 2004 81-81184-02 REV A01
Generally, the Limited Product and Limited Repair Warranties are contingent upon proper use in the
application for which the product is intended; and do not cover the product if you perform any of the
following actions:
• Modify the product without the manufacturer’s written approval.
• Subject the product to unusual physical, environmental, or electrical stress, including damage
caused by handling or shipping in unapproved containers or packaging.
• Disturb any warranty labels, or the integrity of the product in any other way.
• Remove or damage the serial number label to the extent that warranty status of the product cannot
be determined.
4.2 Safety, Handling, and ESD Protection
Inappropriate or careless handling of SDLT 600 tape drive systems may result in damage to the
product. Follow the precautions and directions to prevent damaging the SDLT 600 tape drive system.
In addition, follow the steps in
Section 4.3, “Pre-Installation Guidelines” to ensure that you have the
correct hardware for your system configuration.
4.2.1 Safety Precautions
For your safety, follow all safety procedures described here and in other sections of the manual.
1. Power off the system before installing or removing the tape drive to prevent the possibility of
electrical shock or damage to the tape drive. Unplug the unit that contains—or is to contain—the
tape drive from AC power to provide an added measure of safety.
2. Read, understand, and observe all label warnings.
3. The POS uses a Class I laser product. This laser product complies with 29 CFR 1200 and 29 CFR
1910 as applicable on the date of manufacture.
W ARNING ! If you open the tape drive chassis, you may become exposed
to invisible laser emission which could be harmful if you are
directly exposed to the beam.