Tandberg Data SDLT 600 - Manual (Page 99)

SDLT 600 Product Manual Appendix A: Super DLTtape I and Super DLTtape II Data Cartridges
81-81184-02 REV A01 March 2004 A-7
A.4 Data Cartridge Write-protect Switch
Each data cartridge has a write-protect switch that you can use to prevent accidental erasure of data.
Before inserting the data cartridge into the tape drive, position the write-protect switch on the front of
the data cartridge (
Figure A-6 ) according to the type of operations you expect to perform.
Figure A-6. Write-Protect Switch on Super DLTtape II Data Cartridge
• Slide the write-protect switch to the left to enable write protection (you can read existing data;
however, you cannot write over existing data on the media, nor append additional data to the
media). When you move the write-protect switch to the left, a small orange rectangle is visible.
This is your visual reminder that you cannot write data to the media.
• Slide the write-protect switch to the right to disable write protection (you can write over existing
data on the media, and you can append additional data to the media unless the data cartridge is
write-protected via firmware). When write-protection is disabled, no orange rectangle is visible.
For more details, refer to Table A-1 on page A-8 .
Orange Indicator
Write-protect
Slide RIGHT to Disable
Write-protection
Write-protection
Slide LEFT to Enable
Rectangle
Switch