Telect MIX 56 - Manual (Page 26)

2 Installation MIX 56 User Manual
2-4 Telect, Inc. 122188-10 A0
• 3/8 in. open-end or socket wrench to attach chassis ground wire to
ground stud
• Wire-wrap tool to attach front cross-connects when used as DSX or to
connect DS1 signals to M13 when used as multiplexer
Also, you must supply 14 AWG (minimum) insulated, stranded wire for
grounding, and a groundable shielded cable for the ethernet port.
Power
CAUTION !
CAUTION! Do not supply power until all connections are made
in accordance with requirements specified in local electrical
codes.
ALERT !
ALERT! Protect this equipment with a listed/approved branch
circuit breaker sufficiently rated to interrupt power at either
–48 Vdc at 1 amp, or 24Vdc at 2 amp. The panel must be acces-
sible when operating the unit.
The chassis must receive 20Vdc to 60Vdc. Since MIX 56 includes active
components, Telect recommends using a dual feed panel to provide input
power redundancy.
Technical Support (USA)
By e-mail: [email protected]
By phone: 888-821-4856 or 509-921-6161
I
NSPECTION
Compare the contents of the MIX 56 shipping container with the packing
list. Call Telect if you are missing anything.
NOTE
Telect is not liable for shipping damage.
If the shipping container is damaged, keep it for the carrier’s inspection.
Notify the carrier and call Telect’s Customer Service Department: