Telect MIX 56 - Manual (Page 60)

4 Software Operation MIX 56 User Manual
4-14 Telect, Inc. 122188-10 A0
2. To log out, type y and press Enter.
The screen displays your user ID (if security is on) and the time you
logged out.
C
ONFIGURING
MIX 56
Each MIX 56 chassis houses two independent systems. When you access
the Craft interface, whether through an Ethernet port on the rear or a Craft
port on the front, your settings and configurations pertain only to the sys-
tem on the same side of the chassis as the port to which you connected. The
system on the other side is completely unaffected.
Specifying System Settings & M13 Card Functions
In the System Settings screen, you can specify a system’s general settings
and reset either M13 card. General settings include the date and time, the
active M13 card, and times for the Alarm Cutoff and inactivity timer. The
System Settings screen also displays the system’s chassis, alarm card, and
software versions.
To Specify a System’s Settings
Step Action
1. From the Directory screen, press 5 to select System Settings, then
Enter. The System Settings screen appears:
MIX 56 by Telect MIX 56 Directory (Ctrl+D)
Help (?)
System Settings
---------------
System Name: MIX 56 Active Card: 2
System Location: Redundant M13 Cards: Yes
Contact Person: ACO Time: 15 min.
(dd/mon/yy) Date: 08/Jul/02 Inactivity Timeout: 15 min.
(hh:mm:ss) Time: 10:56:03 Loopback Permission: No
AIS Terminates LB: Yes (as per T1.403) Reset: Standby Card
Low Speed Type: T1 Control: Local
LS Remote LB Dir: DS3 Telnet TL1: No
Chassis Version: B0
Alarm Card Version: A1
Card 1 Card 2
------------ ---------
M13 Board Version: 302950-A1 302950-A1
Firmware Version: 2.03 2.03
CPLD Version: A1 A1
Serial Number: 0005C40000AA 0005C40000E5