Telect MIX 56 - Manual (Page 77)

MIX 56 User Manual 4 Software Operation
122188-10 A0 Telect, Inc. 4-31
click the Open button. On clicking the Open button ProComm will send
the file to the Mix56. NOTE, this file must have been previously
saved with the save to a file options of screen 3.
WARNING: This sets up your baud rate and network settings which if
are changed from your current settings will cause you to lose your
connection.
Are you sure you want to restore from a file? y/n n
ProComm is a registered trademark of Symantec Corporation.
b. On pressing y and Enter the prompt appears:
Waiting for data, Send the file.
If you decide not to send the file press the Escape Key.
c. If you’re using ProComm make sure the file transfer proto-
col is set to “RAW ASCII” and then open the “Data” win-
dow and select the “Send File…” option.
d. Select the file and click the “Open” button. ProComm will
open the Sending file window and send the file.
NOTES
- The file must have been previously saved via one of the save
file options of the Save Configuration screen.
- Restoring the NVRam from a file results in a reboot of the
Mix56 card.
• If you selected option 6, “TFTP, Restore From a File”,
a. A warning prompt appears, read and understand the warn-
ing, then press y and Enter.
The warning prompt is —
Restoring Configuration from a file:
This will result in a re-boot of the active card causing a momentary
traffic interruption on the DS3 / DS1 lines. The re-boot will also
cause this craft session to be terminated.
NOTE: This file must have been previously saved with one of the save
to file options of screen 3. Screen 10's "Filename" and "TFTP Host IP
Address" fields must be filled out with the filename and the TFTP
server's IP address. The file retrieved from the TFTP server has a
base filename as specified on screen 10 with a filename extension
".nvr" Screen 9's "IP Address" and "Subnet Mask" fields must be
filled out.
WARNING: This sets up your baud rate and network settings which if
are changed from your current settings will cause you to lose your
connection.
Are you sure you want to restore from a file? y/n n
b. If your network is up and running, i.e. screen 9’s IP address
and subnet mask is set. Also if you’ve set the filename and
TFTP host IP address on screen 10. Then press y and Enter.