Tektronix K1297-G20 User Manual
Page 140
Appendix A: Interfaces
A-40
K1297-G20 Monitor User Manual
Each terminal socket is equipped with two LEDs for displaying the line
status. Each of the line connectors labelled “to DTE” and “to DCE” are
assigned two LEDs. These display the line status as shown in the following
table.
Table A–24: Line status: V./X. interface module
S0
S1
Meaning
on
on
While booting: Reset of the interface
off
off
After booting: Port not in operation
alternating
with S1
alternating
with S0
Port initialized. No adapter cable connected (operational
state)
on
off
Port initialized. Adapter cable connected (operational
state)
on
on
Port initialized. Data traffic is possible (operational state):
Case 1:
– with V.35 or V.24 cable to DTE
– receiver ready
– line status Data Terminal Ready has been reached
Case 2:
– with V.35 or V.24 cable to DCE
– and receiver ready
– line status Data Set Ready has been reached
Case 3:
– with X.21 cable to DTE
– and receiver ready
– if line status Control has been reached
Case 4:
– with X.21 cable to DCE
– receiver ready
– if line status Indication has been reached