Tektronix K1297-G20 User Manual
Page 155
Appendix A: Interfaces
K1297-G20 Monitor User Manual
A-55
Ethernet Modules
Two independant high performance Fast Ethernet interface controller ports
(RJ45 connectors) are on an Ethernet module.
1
Table A–31: Front Panel I/O Pin Assignment
Pin
Signal
Pin
Signal
1
TX +
5
Not connected
2
TX –
6
RX –
3
RX +
7
Not connected
4
Not connected
8
Not connected
Each Ethernet port provides a set of four LED status indicators on the front
panel with the following information:
Rx
Traffic is sensed on the network.
Tx
A data packet is sent.
The LEDs have the following meaning:
LINK
Link integrity: LED is on means, link is good in
either 10 or 100 Mbps mode.
LED is off means, link is bad.
100
Speed: LED is on means, the data rate is 100 Mbps.
LED is off means, the data rate is at 10 Mbps.
LED retains its last known state when the link is down.