Tektronix K1297-G20 - Manual (Page 56)

Getting Started
44 K1297-G20 Monitor User Manual
Pre-Installation Checks
1. Ensure that the system date and time have been set to the actual date
and time. Failure to do so may result in a situation where the software
cannot be started.
2. Ensure that your boards meet the following memory requirements:
H E1/DS1 Monitoring boards: 16 MB RAM minimum
H BAI boards: 8 MB RAM minimum
At least 16 MB (recommended 32 MB) of memory are required for
interface boards that are installed with VME bus address 1. (See
chapter ”Setting the VME Bus Address”).
NOTE. Cards that do not meet these requirements are NOT booted and
CANNOT be operated. A message will appear in the K1297-G20
Monitor Status Window if memory is not sufficient. If a RAM upgrade is
required, please contact your technical support representative.
3. Remove the content of the directory C:K1297\bin
The installation of a new K1297-G20 Monitor software over an
existing K1297-G20 Monitor software can cause problems with
non-existing licenses. To avoid this problem remove the content of the
directory
C:\K1297\bin of the exiting software version before you
install the new version. This can be done with the Windows Explorer
or on the command line with
del c:\K1297\bin\*.*