Tektronix K1297-G20 - Manual (Page 153)

Appendix A: Interfaces
K1297-G20 Monitor User Manual A-53
The SERIAL interface (RJ45 connector) can be used as asynchronous
serial debug port for service purposes.
1
Table A–29: Pin assignment for the SERIAL interface (DTE)
Pin Assignment Pin Assignment
1 DCD 5 RxD
2 RTS 6 Ground
3 Ground 7 CTS
4 TxD 8 DTR
In addition an RJ45 10-BaseT/100-BaseT connector is provided on the
front panel (for future use, not yet supported).
Table A–30: Pin assignment for the 10-BaseT/100-BaseT interface
Pin Assignment Pin Assignment
1 TX + 5 Not connected
2 TX – 6 RX –
3 RX + 7 Not connected
4 Not connected 8 Not connected