Tektronix K1297-G20 - Manual (Page 59)

Getting Started
K1297-G20 Monitor User Manual 47
To install additional software packages, proceed as follows:
1. Close all applications.
2. Connect the optional external CD drive directly to your Protocol Tester
or create an access to a network CD drive.
If you install the software from a CD network drive, do not browse the
network neighborhood to access this location. Map the share
containing the CD to an unused drive letter instead, such as ”E:”
or ”F:”
3. Insert the key disk into the floppy disk drive of the Protocol Tester.
The key disk contains a serial number, which must be the same as the
nameplate fabrication code (Ser.-No.) on the back of the device.
4. Insert the installation CD into the CD drive. The Setup Guide starts
automatically. The Setup Guide helps you to successfully install your
Protocol Tester software. Follow the Setup Guide instructions.
If the installation does not start automatically, double-click
RunIntro.bat from the CD root directory.
Follow the setup program instructions. Read the enclosed license
agreement carefully and respond to the prompts.
Specify a valid keyfile within the keyfile selection dialog box, if you
do not want to use the
keyfile.txt on the key disk in the floppy
disk drive.
In the subsequent dialog boxes, click Next .