Trango Broadband Access5830 - Manual (Page 15)

Getting Started
Trango Broadband Wireless — Access5830 User Manual Rev. F page 11
Reset Button on FOX Series Radios
FOX Series radios feature a reset button that can be pressed with a small object such as a paper clip. Pressing the reset
button will reset the radio’s IP address to factory default of 192.168.100.100, and password trango. The reset button can
be useful if you forget or are unsure of the radio’s IP address/password.
Serial Port on M5830 Series Radios
M5830 Access Points and Subscriber Units feature a
serial port. The serial port is useful in the event that the
radio cannot be accessed via TCP/IP (HTTP or Telnet).
A Terminal Emulation program (such as HyperTerminal
on the Windows operating system) can be used to access
the radio’s CLI using the radio’s serial port, which is
located behind the RJ-11 access cover on the bottom of
the radio. A serial programming cable has been provided
with each AP for this purpose. The same cable may be
used for subscriber units. To terminate a CLI session
(Telnet or Serial) type the command logout. Type help
or ? for a listing of all CLI commands. Type help
[<command>] for the syntax of a particular command.
Figure 4-5: Pin-outs for Serial Cable
!
Note: Serial management (via the RJ-11 port) is
possible on both APs and SUs regardless of Opmode and
switch settings.
Figure 4-6: Terminal Settings
!
Note: If you have forgotten your password, follow the following directions:
1. Connect you PC to the radio with the serial cable.
2. Open HyperTerminal.
3. Power cycle the radio.
4. While it is loading, you will be able to see this in HyperTerminal, press enter.
5. Type resetpassword.
6. Type main. This will continue the loader.
The password is now trango.