Trango Broadband Access5830 - Manual (Page 60)

Management
Trango Broadband Wireless — Access5830 User Manual Rev. F page 56
Command Description
AP/S
U Remarks
reset [<all | 0...n>]… reset radio to factory default settings
Parameters are in groups.
The following parameters will be
reset for the AP:
0 - BASE ID = 1, AP ID = 1
Subnet Mask =
255.255.255.0
Gateway = radio IP
Password = trango
1 - Channel Tables
Active Channel = 1 h
2 - TX Power = Max
RF Threshold = -90 dBm
Target RSSI = -60 dBm
Service Radius (ISM/UNII)
= (10/4) mi
MIR Threshold = off
3 - SNMP Community String
(Read/Write) =
(public/private)
SU:
0 - BASE ID = 1, AP ID = 1
SU ID = 1
Subnet Mask =
255.255.255.0
Gateway = radio IP
Password = trango
1 - Channel Tables
Scan Table = 1 h 7 h
Active Channel = 1 h
2 - TX Power = Max
RF Threshold = -90 dBm
Both Examples:
reset all – resets parameters 0-3.
reset 0 – resets Base ID, AP ID,
subnet, gateway, and password.
reset 1 - resets channel tables
Note: parameter #3 does not
apply to SU
restart same as “reboot”
rfrxth [<ism | unii> <-90|-85|-80|-75|-70|-65>] specify RF RX Threshold Both default = -90 dBm for both bands
rfrxthreshold … same as “rfrxth” Both
rssi display current RX RSSI from
associated radio Both
rssi r + display RX RSSI continuously Both
save same as “updateflash” Both Examples:
save ss (save system settings)
save sudb (save SUDB changes)
save mainimage (update flash
memory with new firmware)
set apid <ap-id> set AP ID, <ap-id> = 1..255 Both
set baseid <base-id> set base station id, <base-id> =
1..127 Both
set defaultopmode ap <mins> set default Opmode to be AP, <min>
= 0..10 AP default Opmode is AP, 0 = 30 s
set defaultopmode su <mins> set default Opmode to be SU, <min>
= 0..10 SU default Opmode is SU, 0 = 30 s
set gateway [<ip address>] set or display gateway’s IP AP If IP is 0.0.0.0, or