Appendix b command set reference – Trango Broadband Access5830 User Manual
Page 58
Management
Trango Broadband Wireless — Access5830 User Manual Rev. F
page 54
Appendix B Command Set Reference
+ indicates command may not work properly through HTTP’s command console.
Command Description
AP/S
U
Remarks
?
display complete help pages
both
? <command>
display list of command’s syntax
both
_password <new password> <new password> specify new password (max 15 octs)
both
apsearch <sec> <ch #> <v | h> <ch #>
<v | h>]…+
monitor traffic from all APs
both
baud [<9600 | 115200>]
display or set console baud rate
both
default = 9600 bps.
bcastscant <all | suid> <ch#> <h | v>…
broadcast new scan and channel
frequency table to a single or all SUs
AP
up to 31 channels and
polarizations available
AP will broadcast packet every
second for 60 mins
Example: bcastscant all 3 v 2 h
bcastscant stop
stop bcastscant AP
bye
same as “logout” both
date
display current date
both
date [<mm> <dd> <yy>]
set current date
<mm> = 1..12 <dd> = 1..31 <yy> =
1..99
AP
echo [<on | off>]
echo input characters in telnet
both
default = on. If double
characters appear while typing in
the radio’s CLI, the echo off
command will cure the problem.
eth <link | r | w | reset>
display or set Ethernet setting
both
exit
same as “logout” both
freq
display current channel
Both
freq <ch#> <h | v>
change current channel and
polarization
Both Example:
freq 6 v
Note: This command is typically
used to temporarily change a
radio’s channel.
freq channeltable
display channel table
Both
freq scantable
display scan sequence table
Both
freq writechannel [<ch #> <freq>]…
build channel and write to flash
<ch #> = 1..30, <freq> = 5736..5836
Both
channel # 31 is invalid.
Example:
freq writechannel 5 5755 6 5775
freq writescan [<ch #> <h | v>]
set active channel and polarization
AP
Use this command to change
channel and polarization, and
write to flash.
freq writescan [<ch #> <h | v>]…
build scan sequence in SU
<ch #> = 1..30
SU
channel # 31 is invalid.
Example:
freq writescan 1 h 2 v 3 h
help
display complete help text
Both
help <command>
displays list of command’s syntax
Both
heater [<on temp> <off temp>]
changes the turn-on and turn-off
temperature threshold (in
°C) of the
radio’s internal heater
Normally the user will not need
to alter this setting.
Example: heater 0 10