Trango Broadband Access5830 - Manual (Page 61)

Management
Trango Broadband Wireless — Access5830 User Manual Rev. F page 57
Command Description
AP/S
U Remarks
255.255.255.255, radio will not
ping gateway.
set httpport [<port #>] set or display HTTPD port number Both default = 80
set mir <on | off> enable or disable MIR threshold AP default = off
set mir threshold [<kbps>] set MIR threshold, <kbps> =
1000..9999 AP default = 6114 kbps (6 Mbps)
set rssitarget <dB> set Target RSSI to be received from
SUs
AP It must be in the range -45 to -75
and +5 dB higher than RF RX
Threshold.
set serviceradius [<ism | unii> <miles>] set or display service range, <miles>
= 0 .. 30 AP default: ISM = 10 miles
UNII = 4 miles
Used for determining timeout
duration in polling sequence.
Does not actually determine
service range.
set snmpcomm [<read | write | trap (id | setall
str)>] display or assign SNMP community
string AP Community string is SNMP’s
password.
set suid <su-id> specify unit’s SU ID SU After changing SU ID it is
recommended to reboot the
radio.
set telnetport [<port #>] specify telnet port, <port #> =
1..65534 Both default = 23
ssrssi <ch #> <v | h> display RSSI on the current channel Both Useful for antenna alignment.
To stop the continuous readout
hit space, enter.
su display the SU info summary AP
su <suid> display SU payload status AP
su all display all registered SU AP
su info <su-id> display request SU’s info:
1. H/W version
2. F/W date code
3. FPGA version
4. Image checksum
5. Device ID
6. IP address
7. Scan sequence table
8. Packet
filter on/off
9. Auto scan AP on/off
10. TCPIP for AP on/off
11. HTTPD on/off
12. Remarks
AP
su ipconfig <new ip> <new subnet>
<new gateway> assign radio’s IP, subnet mask, and
gateway IP AP
su live display all SUs that are associated AP
su password <all | suid> <pwd> <pwd> set SU’s password remotely AP
su ping <su-id> request SU’s ranging and RSSI
information AP
su powerleveling <all | suid> [<target, dB>] calibrate SU’s power leveling AP Target RSSI in dB
su poweroff display all SU that are in the
“poweroff” group AP
su priority display all SUs that are in the
priority group AP