Trango Broadband Access5830 - Manual (Page 19)

Basic Configuration via Browser Interface
Trango Broadband Wireless — Access5830 User Manual Rev. F page 15
Connect to the AP (see Getting Started) and open the Configuration page.
1. Set the Base ID. (Must match the SU.)
2. Set the AP ID. (Used to identify the AP, not essential in establishing a link.)
3. Set the IP, Subnet, and Gateway. (Not essential for a link.)
4. Set the Default Opmode to "AP."
5. Set the Active Channel and Polarization. (Must match at least one set in the SU Scan Table.)
6. Click Save and Activate Settings.
7. If you changed the IP address, log onto the radio using the new IP address.
8. Start Opmode “AP” by rebooting (click Reboot System), or click Activate Opmode.
At this point the AP will begin actively searching for any SU in its SUDB. Once an active SU is detected, the
authentication and association process will begin. When the AP is in Opmode “AP,” the red LED on the bottom of the
AP should be solidly lit, indicating that the radio is in Opmode “AP” and transmitting.