Trango Broadband Access5830 - Manual (Page 54)

Management
Trango Broadband Wireless — Access5830 User Manual Rev. F page 50
AP Advanced Setup Page
Note: The Advanced Setup page is divided into three sections: ISM, U-NII, and Channel Table. There is a different range for
parameters in ISM and U-NII bands. Remember to Save and Activate Settings.
RF TX Power: Sets the
conducted RF power output
of the radio. This does not
include antenna gain. A
higher number is more
powerful.
RF RX Threshold: Sets the
receive threshold of the AP.
The AP will not process
signals received below this
level, so it is very useful for
interference mitigation. For
a smaller radius of operation
use a higher threshold (-65 is
higher than -70).
Target RSSI from SU:
Used to adjust the RF power
level of the SUs so they all
have roughly the same level
at the AP. Make sure that all
SUs are power leveled after
changing this number (See
Link Control page).
Channel Table: Assigns
channel numbers to actual
frequencies of operation.
Default settings allow the
largest number of channels.