Trango Broadband Access5830 - Manual (Page 63)

Management
Trango Broadband Wireless — Access5830 User Manual Rev. F page 59
Command Description
AP/S
U Remarks
group 0: disabled group
sudb view display all entries in SUDB AP
sulog display last SU log
1. Time tag (ms)
2. Sample period (1..60 mins)
3. RF receives user payload in
Kbytes
4. RF transmits user payload
in Kbytes
5. Local Ethernet receives
user payload in Kbytes
6. Local Ethernet transmits
user payload in Kbytes
7. RSSI
8. TX
power
8. Temp
AP default sample period = 10 mins
sulog <# of entry, 1..18> display SU log entry (#) AP up to 18 entries (3 hours)
sulog lastmins [<time stamp, sec>] If time stamp = current up time
stamp, then will display last SU log.
Otherwise will display:
[#Begin]
[#None]
[#End] AP
sulog sampleperiod [<1..60>] set or display SU log sample period AP default sample period = 10 mins
survey <ism | unii> <sec> <h | v> spectrum analysis pf the entire band Both Example: survey ism 30 h
sw display current switch settings Both
sw 0 [<on | off>] packet filter for broadcast/multicast
On = filtering Both default = on
need to update flash
sw 1 [<on | off>] enable SU to autoscan searching
each channel in scan table for AP
On = Autoscan enabled SU default = on
need to update flash
sw 2 [<on | off>] TCP/IP service for AP. Allows
TCP/IP access to SU from AP side
of network via wireless link. SU default = off
need to update flash
sw 3 [<on | off>] enable SU to SU feature (peer-to-
peer) AP default = off
need to update flash
sw 4 [<on | off>] broadcast time stamp to SU (AP
only) AP default = off
need to update flash
sw 5 [<on | off>] HTTPD browser interface enable /
disable. On = enabled Both default = on
need to update flash
sw 6 [<on | off>] TCP/IP Access to Ethnernet port of
SU while radio is in Opmode SU SU default = on
need to update flash
sysinfo display system configuration Both
temp display current temperature Both Note: FOX series SU does not
include an internal temperature
sensor. FOX series radio
receives its temperature from the
AP, as long as AP is running
current firmware. If AP is
running older firmware, FOX
Series SU will report
temperature of 35
° C.