TDK GENESYS 1500W - Manual (Page 35)

83-507-013 Rev. D
27
CHAPTER 4 FRONT AND REAR PANEL CONTROLS AND CONNECTORS
4.1 INTRODUCTION
The Genesys
TM
Power Supply series has a full set of controls, indicators and connectors that allow the
user to easily setup and operate the unit. Before starting to operate the unit, please read the following
Sections for explanation of the functions of the controls and connectors terminals.
-Section 4.2: Front Panel Controls and Indicators.
-Section 4.3: Rear Panel Connections and Controls.
4.2 FRONT PANEL CONTROLS AND INDICATORS
See Fig.4-1 to review the controls, indicators and meters located on the power supply front panel.
Table 4-1: Front Panel controls and indicators
Number Control/Indicator Description Section
1 VOLTAGE control High resolution rotary encoder for adjusting the Output
Voltage. Also adjusts the OVP/UVL levels and selects the
Address 5.2.1
5.3.1
5.4.1
7.2.2
2 VOLTAGE indicator Green LED, lights for constant-Voltage mode operation.
3 VOLTAGE display 4 digit, 7-segment LED display. Normally displays the Out-
put Voltage. When the PREV button is pressed, the display
indicates the programmed setting of the Output Voltage.
When the OVP/UVL button is pressed, the Voltage display
indicates the OVP/UVL setting.
Fig.4-1: Front panel controls and indicators
VOLTAGE
ALARM FINE PREV/
OVP
UVL
FOLD REM/LOC OUT
DC AMPS
CURRENT
DC VOLTS
POWER
1
14
17 18
19
2
15
16
3
13
10
4
11
5
12
9
6
7
8