TDK GENESYS 1500W - Manual (Page 8)

83-507-013 Rev. D
TABLE OF CONTENTS
7.10.6 Status Control Commands……………………………………………………………….. Pg. 62
7.11 STATUS, ERROR AND SRQ REGISTERS………………………………………………….. Pg. 62
7.11.1 General Description……………………………………………………………………….. Pg. 62
7.11.2 Conditional Registers……………………………………………………………………… Pg. 63
7.11.3 Service Request: Enable and Event Registers…………………………………………. Pg. 64
7.12 SERIAL COMMUNICATION TEST SET-UP.…………………………………………………. Pg. 67
CHAPTER 8 ISOLATED ANALOG PROGRAMMING OPTION………………………………… Pg. 68
8.1 INTRODUCTION…………………………………………………………………………………… Pg. 68
8.2 SPECIFICATIONS…………………………………………………………………………………. Pg. 68
8.2.1 0-5V/0-10V option…………………………………………………………………………… Pg. 68
8.2.2 4-20mA option……………………………………………………………………………….. Pg. 68
8.3 ISOLATED PROGRAMMING & MONITORING CONNECTOR……………………………… Pg. 69
8.4 SETUP AND OPERATING INSTRUCTIONS…………………………………………………… Pg. 70
8.4.1 Setting up the power supply for 0-5V/0-10V Isolated Programming and Monitoring… Pg. 70
8.4.2 Setting up the power supply for 4-20mA Isolated Programming and Monitoring…….. Pg. 70
CHAPTER 9 MAINTENANCE………………………………………………………………………... Pg. 71
9.1 INTRODUCTION…………………………………………………………………………………… Pg. 71
9.2 UNITS UNDER WARRANTY……………………………………………………………………... Pg. 71
9.3 PERIODIC MAINTENANCE………………………………………………………………………. Pg. 71
9.4 ADJUSTMENT AND CALIBRATION…………………………………………………………….. Pg. 71
9.5 PARTS REPLACEMENT AND REPAIRS……………………………………………………….. Pg. 71
9.6 TROUBLESHOOTING…………………………………………………………………………….. Pg. 71
9.7 FUSE RATING……………………………………………………………………………………... Pg. 72