TDK GENESYS 1500W - Manual (Page 63)

83-507-013 Rev. D
55
7.8.3 Initialization Control Commands
# Command Description
1 ADR n ADR is followed by address, which can be 0 to 30 and is used to access the
power supply.
2 CLS Clear status. Sets FEVE and SEVE registers to zero (refer to Section 7-11).
3 RST Reset command. Brings the power supply to a safe and known state:
Output voltage: zero,
Remote: non-lockout remote,
Output current: zero, Auto-start: Off,
Output: Off, OVP: maximum,
FOLD: Off, UVL: zero
The conditional registers (FLT and STAT) are updated, the other registers are
not changed.
4 RMT
Sets the power supply to local or remote mode:
1.
RMT 0 or RMT LOC, sets the power supply into Local mode.
2. RMT 1 or RMT REM, sets the unit into remote mode.
3. RMT 2 or RMT LLO, sets the unit into Local Lockout mode (latched remote mode).
5 RMT? Returns to the Remote mode setting:
1. “LOC” - The unit is in Local mode.
2. “REM” - The unit is in Remote mode.
3. “LLO” - The unit is in Local Lockout (latched remote) mode.
6 MDAV? Returns MD MODE OPTION Status. 1 indicates installed and 0 indicates not in-
stalled.
7 \
Repeat last command. If \<CR> is received, the power supply will repeat the last
command.
7.8.4 ID Control Commands
# Command Description
1 IDN? Returns the power supply model identification as an ASCII string: LAMBDA, GENX-Y
2 REV? Returns the software version as an ASCII string.
3 SN? Returns the unit serial number. Up to 12 characters.
4 DATE? Returns date of last test. Date format: yyyy/mm/dd
7.8.5 Output Control Commands
# Command Description
1 PV n
Sets the output voltage value in Volts. The range of voltage value is described in
Table 7-5. The maximum number of characters is 12. See the following examples
for PV n format: PV 12, PV 012, PV 12.0, PV 012.00, etc…
2 PV?
Reads the output voltage setting. Returns the string “n” where “n” is the exact
string sent in the PV n command. When in Local mode, returns the PREVIEW
(front panel) settings in a 5 digit string.
3 MV?
Reads the actual output voltage. Returns a 5 digits string.
Example: 60V supply sends 01.150, 15.012, 50.000, etc…
4
PC n
(See
Note 1)
Set the Output Current value in Amperes. The range of current values is de-
scribed in Table 7.6. The maximum number of characters is 12. See the following
examples for PC n format: PC n format: PC 10, PC 10.0, PC 010.00, etc…
5 PC?
Reads the Output Current setting. Returns the string “n” where “n” is the exact
string sent in the PC n command. When in Local mode, returns the PREVIEW
(front panel) settings in a 5 digit string.
6
MC? (See
Note 2) Reads the actual Output Current. Returns a 5 digit string.
Example: 200A supply sends 000.50, 110.12, 200.00, etc…