TDK GENESYS 1500W - Manual (Page 38)

83-507-013 Rev. D
30
Table 4-2: Rear panel connections and controls
Number Item Description Section
1
AC input
connector Wire clamp connector for 1500W units.
IEC connector for 750W units. 3.7.1
3.7.2
2 DC output Bus-bars for 6V to 60V models.
Wire clamp connector for 80V to 600V models. 3.9.6
3 Remote-In
connector RJ-45 type connector, used for connecting power supplies to
RS232 or RS485 port of computer for remote control purposes.
When using several power supplies in a power system, the first
unit Remote-In is connected to the computer and the remaining
units are daisy-chained, Remote-In to Remote-Out.
7.3
7.5
4
Remote Out
connector RJ-45 type connector, used for daisy-chaining power supplies to
form a serial communication bus. 7.3
7.5
5 J1 Analog
Remote
connector Connector for remote analog interface. Includes Output Voltage
and Current programming and monitoring signals, Shut-off control
(electrical signal), Enable/Disable control (dry-contact), Power
Supply OK (PS_OK) signal and operation mode (CV/CC) signal.
6 SW1 Setup
switch Nine position DIP-switch for selecting remote programming and
monitoring modes for Output Voltage, Output Current and other
control functions. 4.4
7
J2 Remote
sense
connector Connector for making remote sensing connections to the load for
regulation of the load voltage and compensation of load wire drop.
3.10
3.8.2
8 Blank
Sub-plate Blank sub-plate for standard units. Isolated Remote Analog pro-
gramming connector for units equipped with Isolated Analog con-
trol option. IEEE connector for units equipped with IEEE pro-
gramming option (shown). Fig.4.2
9 IEEE switch Two position DIP-switch for selecting IEEE mode or RS232/RS485
mode when IEEE option is installed. Fig.4.2
10 Ground
screw M4x0.7, 8mm long DBL-SEMS screw for chassis ground
connection.
Fig.4.2
4.4 REAR PANEL SW1 SETUP SWITCH
The SW1 Setup switch (see Fig.4-3) is a 9-position DIP-switch that allows the user to choose the
following:
 Internal or remote programming for Output Voltage and Output Current.
 Remote voltage or resistive programming of Output Voltage and Output Current limit.
 Select range of remote voltage and resistive programming.
 Select range of output Voltage and Output Current monitoring.
 Select the Remote Shut-Off control logic.
 Select between RS232 and RS485 communication interface.
 Enable or disable the rear panel Enable/Disable control (dry contact).