TechniSat CAM 1 plus - Manual (Page 10)

4.4 Setting the UHF Output Channel
The procedure is as follows:
>
Use the Menu key to select the Main Menu.
> Now select the entry Settings, marking it in blue by using the
up/down arrow
keys
> Confirm by pressing OK.
The sub-menu Settings will be displayed.
> Now use the
up/down arrow
keys to mark the line
Audio/Video Settings
> Confirm by pressing OK ..
The sub-menu Audio/Video will be displayed.
> Now select the line
UHF Out Channel
, marking it in blue by using the
up/down
arrow keys.
> Select a free UHF channel on your TV set in the range between 21 and 69.
> Finally, use the
numeric key pad
to enter the new output transmission channel in
your receiver's memory.
The receiver will now transmit the signal on the UHF channel shown in the display.
Should you still experience interference on the channel selected, please repeat the
procedure until you find a suitable channel, free from interference.
10
bed_anl_TechniBox CAM1plus_engl.qxd 30.03.01 14:50 Seite 10