TechniSat CAM 1 plus - Manual (Page 43)

TechniLink data-communication via pin 10
Serial Interface RS 232:
Type
RS 232 bi-directional
Bitrate Max. 115.2 Kbit/s
Connection 9-pin D-SUB connector
Function Pre-programming and updating operational software
PLL-Modulator:
Output range
UHF channels 21 to 69
Antenna input 47….862 MHz
Input impedance 75 Ohm
Antenna output 47…862 MHz
Output impedance 75 Ohm
LNB power supply:
LNB power
Max. 400 mA, double-insulated
LNB voltage vertical <14.0 V no load, 11.5 V at 400 mA
LNB voltage horizontal <20 V no load, >17.5 V at 400 mA
LNB switched off in Standby mode
22 kHz-Modulation: 22 kHz, amplitude 0.6 V +/- 0.2 V
Programme memory/ Satellite positions:
No. of programmes user list TV:
999 TV programmes (F1 to F999)
No. of programmes user list Radio: 999 radio programmes (r1 to r999)
Number of Programmes:
Bouquet lists TV/Radio
total of 4000 programmes possible in bouquet lists
Number of active satellite positions:
Max. 4 (DiSEqC 1.0, SAT POSITION/ SAT OPTION)
Total number of satellite position: 32
One home transponder is stored in memory for each of the 32 satellite positions. This trans-
ponder facilitates automatic channel/programme search on each satellite position.
EPG Data:
EPG preview:
Maximum 7 days in advance
Memory capacity: 300 kBytes
Programmable for a maximum of 50 programmes
Timer:
Events
Maximum 128 events, one year in advance
Remote Control System: RC-5
Sub-system address 8 (SAT 1)
Modulation frequency 36 kHz
Infrared wavelength 950 nm
43
bed_anl_TechniBox CAM1plus_engl.qxd 30.03.01 14:50 Seite 43