TechniSat CAM 1 plus - Manual (Page 38)

> Use the up/down arrow keys to mark the entry Factory Settings .
> Confirm with the OK key.
The sub-menu
>Factory Settings
will be displayed.
7.9.1 Restore Factory Settings
This function will delete all personal settings, and will restore all default settings as progra-
med in the factory.
7.9.2 Delete All Programs
This function will delete all channels/programmes stored in memory.
>
Use the up/down arrow keys to select the entry.
> Confirm with the OK key.
Please note any notes and information displayed on the screen.
7.9.3 Service Channel
In addition, your receiver provides a facility for its operating software to be updated via satel-
lite (ASTRA at 19° East).
>
Press the
OK
key to call up the sub-menu
Software
> In order to update the software, mark the entry Download enabled.
> Confirm yes by pressing the OK key.
> Read the note displayed on screen, and confirm with the
OK
key.
> Press the Menu key to return to normal operation.
In order to load the updated software overnight, the receiver must be left
in the Standby mode. The progress of the download will be indicated by
"SatL" on the display. This download should NOT be interrupted by swit-
ching the receiver on or off while it is in progress.
When the software has been fully loaded, the function Download enabled will be automatical-
ly reset to
no
.
Should the parameters of the data channel for the download of software updates be chan-
ged, you can correct them in this menu as described under points 7.7.3 and 7.7.4 (search for
transponders and programmes). Current transponder information can be obtained from your
retailer, or from our homepage in the Internet. Under normal circumstances you should not
change the settings in this menu.
38
bed_anl_TechniBox CAM1plus_engl.qxd 30.03.01 14:50 Seite 38