TechniSat CAM 1 plus - Manual (Page 44)

Power supply:
Mains switch:
Power usage:
<28 W (in operation, horizontal polarisation, 400 mA supply to LNB)
<19 W (in operation, excluding LNB)
< 5 W (in standby mode)
Mains voltage:
230 V /50 Hz AC
General:
Ambient temperature
+ 15° C ….+ 35° C
Humidity < 80 %
Dimensions (WxDxH) 370 mm x 270 mm x 65 mm
Weight 0.8 kg
10 Troubleshooting Guide
44
Problem
No picture, no sound,
Display off
No picture, no sound,
Display on
Picture shows intermittent blocks.
May switch to still image, no
sound, at times screen black and
note "No signal"
Sound OK, screen blue
Switch to TV mode
Possible Cause
No power
Short circuit in LNB connection
Defective or missing cable
connection
LNB defective
Wrong external unit set on recei-
ver
Dish positioned incorrectly
Heavy rain or snow
Dish positioned incorrectly
Dish too small for this location
Obstruction between dish and
satellite (e.g. tree)
Radio mode selected
SCART connector not properly
Inserted
Solution
Check power plug and cable
Switch receiver off, repair short,
switch receiver on again
Check all cable connections
Replace LNB
Correct setting (see point 5.4)
Correct dish position
Clear dish of snow
Correct dish position
Use larger dish
Mount dish with uninterrupted
view
Switch to TV mode
Check SCART connections
bed_anl_TechniBox CAM1plus_engl.qxd 30.03.01 14:50 Seite 44