TechniSat CAM 1 plus User Manual
Page 28
The timer can be programmed as follows:
Date
>
Use the
arrow
keys to mark the Date column
>
Use the
numeric key pad
to enter the date on which you wish to record a pro-
gramme
Start
>
Use the
right arrow
key to mark the Start column.
>
Use the
numeric key pad
to enter the starting time for the timer.
Stop
>
Repeat the steps shown under "Start" to enter the time when the timer should stop,
i.e. be switched off.
In order to ensure a smooth operation, there should be a gap of at least one minute
between the end of one timer period and the start of the next timer period!
Switching Timer on - Repeat
>
Use the
right arrow
key to mark the column
Rpt
.
>
If required, switch the timer on by pressing the
OK
key (Display
1x
)
>
By repeatedly pressing the
OK
key you can set the timer for further days as follows:
Status
>
Use the
arrow
keys to mark the Status column
>
Use the
OK
key to enter the desired status in this line.
1.VCR
Your equipment will be switched on and off for the selected programme.
Display:
-
Timer off
1x
Timer on
D
Daily repeat
1W
Repeat once per week
2W
Repeat every two weeks
3W
Repeat every 3 weeks
4W
Repeat every 4 weeks
1-5
Repeat only on workdays
6-7
Repeat only on weekends
28
bed_anl_TechniBox CAM1plus_engl.qxd 30.03.01 14:50 Seite 28