TechniSat CAM 1 plus - Manual (Page 16)

> Now use the up/down arrow keys to select the entry LNB Settings
> Confirm by pressing the
OK
key.
The menu Settings LNB will be displayed.
The following selections can be made in this sub-menu:
5.4.1 DiSEqC ein- ausschalten
DiSEqC ( D igital Satellite Eq uipment C ontrol) is a digital signal that can control the functions
of DiSEqC-compatible components via the antenna connection.
If your external installation features DiSEqC components, you should enable the DiSEqC
control function:
>
When this entry is highlighted, use the OK key to switch the DiSEqC function on or
off .
5.4.2 Adjusting the Switching Matrix and LNB Properties
The menu reflects the four switching criteria of the DiSEqC control.
Your receiver is pre-programmed to receive ASTRA broadcasts on switch setting A/A, and
EUTELSAT signals on setting B/A of a Multiswitch. Should the switching matrix of your exter-
nal receiving unit be set up differently, or should you wish to receive satellite signals other
than those mentioned, you can adjust the receiver settings as follows:
>
Use the up/down arrow keys to select the DiSEqC switch position (1-4) that you
wish to use for allocation to a satellite (e.g.
A/B 3 No Satellite
), and highlight the
appropriate entry.
> Press the OK key to confirm.
A list of several satellites will be displayed, from which you can make your selection.
> Use the up/down arrow keys to select the appropriate satellite.
Pressing the up/down arrow keys will move the marker by one line at a time, up or
down, while the
left/right arrow
keys will take you to the previous or following
pages respectively.
Should the satellite you are looking for not be included in the list, please select one of
the spare settings, which are marked
User 1
to
User 15
.
> Confirm by pressing the OK key.
The highlighted entry will now be inserted in the Menu >Settings>LNB at the pre-
viously selected position.
16
bed_anl_TechniBox CAM1plus_engl.qxd 30.03.01 14:50 Seite 16